Discussion regarding rifles chambered in 22 TCM
User avatar
By akwxmn
#14278 I reload to 9R OAL. Anything longer will not fit or work in the Glock Mags. For a while I was putting pulled 40gr ARMSCOR bullets in backwards. Much like a wadcutter. Worked just fine. Surprised me. Now I'm using a lead 37g FP GC that I've had success with. I've only been shooting at paper at 25 and 50 yards and mostly just for function. Accuracy looks pretty good. Just don't get to play as much as I would like. Should be getting the ramped barrel back next week.
User avatar
By Turbocavy
#14603 I did some load development this evening. 45 gr soft points, started with 9.8 gr of Lil gun and group size came down as powder charge went up. Ended at 10.2 gr and group of. 375" at 50 yards. Going to start another ladder heading towards 11 gr when I get a chance. Also tried 9.8 gr Imr 4227 for a. 425" group. Going to up to a mag primer for the little unburned powder.
User avatar
By redcaddy51
#15091 Sorry about being so slow to answer, been busy on other projects. I did the machine work to a take off Remington Sendaro fluted SS barrel in 22-250.( PO said it just wouldn't shoot)
I cut off the chamber, left me with 20 inches barrel length, threaded the chamber end 1 inch -16, bored and threaded a piece of 2 inch 4130 steel, screwed in the barrel with an epoxy compound. Turned and threaded the sleeve to fit the Savage receiver, chambered 22 TCM, re crowned the muzzle and test fired.

After a bit of load development, it now shoots .340" at 50 yards, .480 @ 100 yd.